Use a self leveling compound to fill in any low spots.
Concrete floor under carpet.
And in some cases it s even possible to go right over the existing floor covering.
And both of the options use the same layers of 1 2 in.
This can cause issues with mold and mildew especially if you have carpet or.
Instead what is often left behind is course sections of dried adhesive that have bonded to the concrete floor in such a way that they are.
The chosen fiber material type should be a synthetic form such as olefin face fiber.
This isn t the same as having a floor squeak when you step on it which simply indicates that the subfloor isn t tightly fastened to the floor joist in one area.
Plywood carpet pad and carpet as shown.
Is it possible to remove worn carpeting ceramic tile or sheet vinyl from an existing concrete subfloor and then stain or polish it.
Any carpet fiber style from plush to loop can be applied to a concrete floor.
To prevent this chip away bumbs using a hammer and chisel.
Then lay tack strips around the perimeter of the room and install your strips of padding.
Concrete s porous nature means that water from under your home can seep up through your concrete floor making it damp.
For below grade slabs assume that the concrete floor will get damp at some point.
Instead a dip in the carpet could mean that a floor joist has sustained.
After that lay your carpet starting at the center of the room and tightening the carpet with a rented knee kicker as you move toward the walls.
The carpet will be connected to the concrete surface via a series of wooden strips to which the carpet is tacked.
If you can feel a soft spot in the floor under the carpet the subfloor has likely been weakened or damaged.
Removing carpet before installing concrete floors time.
Unfortunately when you remove the carpeting to replace it the adhesive usually does not come off with the carpet in all areas.
While carpet and underlayment will be able to hide some flaws in the concrete sagging or bumby areas may show through.
You then have two options depending on your circumstances.
Remove the 3 foot wide carpet sections from the tack strips by shaking the carpet in a back and forth motion while pulling it up from the surface of the floor.
Carpet that is attached to a concrete floor is usually held down by adhesive.